Identification
Body number and identification plate
The body number is stamped on the base of the passenger seat. The identification plate is located on the frame of the right wing.
Engine number
The engine number is stamped on the cylinder block, in the place indicated by the arrows in the figures.
 |  |
Jacking points
Recommended mounting points for jacks and stands are shown in the figures. Install jacks and stands only at the specified points.
*1 - for models without power steering pump.
*2 - for models with power steering pump.
Mounting points for jacks and stands
Garage jack installation points -
Screw jack installation points:
Front -
Rear end:
Single tires -
Twin tires -
Stand installation points -
Abbreviations
- PCV - forced crankcase ventilation system
- TDC - top dead center
- Timing - gas distribution mechanism
- M3 - tightening torque
- BDC - bottom dead center
- Manual - manual transmission
- automatic transmission - automatic transmission
- 2L, 3L - 2L, 3L engines
- 1Y, 2Y, 3Y - 1Y, 2Y, 3Y motors
- 150 — Dyna 150
- 100 — Dyna 100
- Axle Type A - 8" Reducer
- Axle Type B - 9.5" Reducer
- Axle type C - Reducer 10.5 inches