Removing
1. Disconnect the vacuum hose.
2. Disconnect the oil supply hose.
3. Remove the pump.
A) Loosen the three mounting bolts.
b) Remove pump and O-ring.
Vacuum pump installation
1. Install O-ring and vacuum pump.
A) Install a new O-ring into the groove.
b) Fix the pump with three bolts and tighten them.
- Tightening torque: 7.8 Nm
Vacuum pump.
1 - Vacuum hose,
2 - Fitting,
3 - O-ring,
4 - Vacuum pump,
5 - Hose for oil supply,
6 - Bracket,
7 - Gasket,
8 - Spatula,
9 - end plate,
10 - Pin,
11 - Rotor,
12 - Housing,
13 - Check valve.
2. Install the fitting with new gaskets and tighten the bolt.
- Tightening torque: 14 Nm
3. Connect the oil supply hose and install the clamp.
4. Connect a vacuum hose and establish a collar.