2. Install and press in a new oil seal and apply hydraulic fluid to the lips.
2. Install and press in a new oil seal and apply hydraulic fluid to the lips.
Replacement of oil seals
1. Using the special tool, remove the oil seal from the mounting hole.
2. Install and press in a new oil seal and apply hydraulic fluid to the lips.
2. Install and press in a new oil seal and apply hydraulic fluid to the lips.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Share information:
Installing the gearbox
Gearbox — check
Removing the gearbox
Road test
Hydraulic test
Checking the transfer time
Test on a fully braked car (stall test)
Selector and ignition key lock system
Checking the elements of the electrical part of the control system
Self-diagnosis system
Gearbox — check
Removing the gearbox
Road test
Hydraulic test
Checking the transfer time
Test on a fully braked car (stall test)
Selector and ignition key lock system
Checking the elements of the electrical part of the control system
Self-diagnosis system
Replacing the gearbox input shaft seals
Removal and installation of an epiploon of a cable of a drive of a speedometer
Removal and installation of hoses of a cooler of a working liquid
Replacing the working fluid filter
Removal and installation of the high-speed regulator
Selector lock cable
Start inhibit switch
Main technical data of automatic transmission
Removal and installation of an epiploon of a cable of a drive of a speedometer
Removal and installation of hoses of a cooler of a working liquid
Replacing the working fluid filter
Removal and installation of the high-speed regulator
Selector lock cable
Start inhibit switch
Main technical data of automatic transmission
Similar articles on other Toyota models
➥ Camshaft seals — replacement Toyota Camry XV20 (1996-2001)
➥ Coolant replacement Toyota Corolla E80 (1983-1990)
➥ Wheel replacement Toyota Corona T190 (1992-1997)
➥ Replacement of power shaft seals Toyota Carina T190 (1992-1996)
➥ Front and rear flange seals — replacement Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Inspection and replacement of windshield wiper blades (every 8000 km or 6 months) Toyota Highlander 1 (2000-2007, petrol)
➥ Camshaft seals — replacement Toyota 4Runner N120 (1989-1995)
➥ Air filter replacement Toyota RAV 4 XA10 (1994-2000)
Link in different formats to this article
TEXTHTMLBB Code
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Petrol engines 1.0 l
- Petrol engines 1.3 l
- Engine overhaul
- Cooling system
- Lubrication system
- Fuel injection system
- Starting and charging system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts and cardan
- Chassis, running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Body elements
- Heating and air conditioning
- SRS security system
- Electrical equipment
- Equipment and devices
- Electrical circuits
- Gasoline engines «Y»
- Checks and adjustments
- Overhaul engines
- Cooling and lubrication system
- Fuel system
- Starting and charging system
- Ignition system
- Diesel engines «L»
- Engine repair
- Cooling and lubrication system
- Fuel system
- Starting and charging system
- Transmission
- Clutch
- Mechanical gearbox
- Cardan shaft
- Chassis, running gear
- Car suspension
- Brake system
- Steering
- Electrical equipment and body
- Body elements
- Equipment and devices
- Electrical circuits