EJ-series
1. Using the special tool, connect the tachometer to the output "REV" (8) diagnostic socket.
2. Warm up the engine.
3. Connect the stroboscope as shown.
4. Using the special tool, bridge the leads "T" - "E" ("5" - "13") diagnostic socket.
5. Check the ignition timing.
- Nominal ignition timing - 5°±2°
- Engine speed - 850 rpm
6. If the ignition timing is not correct, rotate the position sensor and adjust the ignition timing.
KZ series
1. Using the special tool, connect the tachometer to the output "REV" (8) diagnostic socket.
2. Warm up the engine.
3. Connect the stroboscope as shown.
4. Using the special tool, bridge the leads "T" - "E" ("5" - "13") diagnostic socket.
5. Check the ignition timing.
- Nominal ignition timing - 6°±2°
Engine crankshaft speed:
- Manual transmission - 650 rpm
- Automatic transmission - 700 rpm
Note: The ignition timing is not adjustable.