Note: Install in the reverse order of removal.
When removing, pay attention to the following operations:
1. Disconnect a wire from the negative plug of the storage battery.
2. Set the steering wheel to the straight ahead position. Loosen the screws on the steering wheel cover.
Table. Steering shaft length.
Note:
- Start removing the steering wheel pad no earlier than one minute after turning off the power supply.
- After disconnecting the wire from the battery, the memory of the electronic control units will be erased.
- Tightening torque - 7 -10 Nm
3. After removal of an overlay of a steering wheel, disconnect a socket of the module of a pillow of safety of a sound signal.
4. Remove the airbag module.
5. Remove the coiled wire.
Note: When installing, turn the coiled wire fully clockwise, then turn it counterclockwise to align the coiled wire position indicator marks.
6. Remove the steering wheel.