Car front and rear suspension Toyota Land Cruiser 60/80

Suspension and steering — design description
FJ60, 62 front suspension parts 1. Nut; 2. Buffer; 3. Plate; 4. Shock absorber; 5. Bolt; 6. Sleeve; 7. Washer; 8. Kingpin; 9. Sleeve; 10. Nut; 11. Stepladder; 12. Plate; 13. Nut; 14. Spring earring; 15. Sleeve; 16. Nut;...

Suspension Specifications
Tightening torques (N·m) Suspension Springs Bolts of fastening of an earring of a spring 81 Ladder nuts 110 shock absorbers front (cars FJ60, 62) Top fixing nut 25 Bottom fixing bolt 59 Rear (cars FJ60, 62) Top mounting...

Front suspension stabilizer and bushing — removal and installation
Removing 1. Raise the front of the car. 2. Remove the stabilizer links. On FJ60, 62 cars, remember the assembly order of the stabilizer link parts - plates and bushings. 3. To remove the rods, it is enough to unscrew...

Front and rear shock absorbers — removal and installation
Front and rear shock absorber 1, 11. Nut; 2. Plate; 3. Front shock absorber; 4, 6, 8. Plate; 5, 7. Sleeve; 9. Nut; 10, 12, 14. Buffer; 13. Bracket; 15. Bolt; 16. Rear shock absorber; 17, 19. Sleeve; 18. Washer; 20....

Springs and bushings — removal, inspection and installation
Checking the condition of the bushings 1. On all vehicles, two bushings are installed in the springs, the condition and tightness of which should be checked periodically. 2. To do this, raise the vehicle to take the...

Suspension springs (car FJ80) — removal and installation
Front suspension Removing Attention! To remove the springs, you will need a tool to compress them. 1. Raise the front of the car and remove the front wheels. 2. Place pedestals under the bridge beam. 3. Disconnect the...

Cross bar (car FJ80) — removal and installation
Removing Attention! The described procedure is the same for front and rear suspension bars. 1. Raise the vehicle. 2. Loosen the nut (arrow) bolts of fastening of a bar to an arm of a spar of a frame. 3. Loosen the nut...

Suspension arms (car FJ80) — removal and installation
Attention! Remove and install each lever individually. If necessary, remove two or more levers, remove the springs and support the axle with a jack. Front suspension arms Removing 1. Raise the front of the car. 2. Place...

Wheels and tires — general information
Tire marking Cars are equipped with radial tires with a metal or fiberglass cord. The use of tires of a different type is not allowed. Tires of the same type with the same pattern must be installed on the same axle....

Front wheel alignment
Front wheel alignment Camber = A-B C - deviation from the vertical D - angle of inclination of the axis of rotation Convergence = E–F G - toe angle The wheel alignment is adjusted by turning the tie rod ends. The camber...