Attention! Wear gloves to avoid cutting your hands on the edges of the technological holes in the door frame!
Lower the glass to its lowest position. On models equipped with power windows/single lock, disconnect the negative cable from the battery.
Attention! If the stereo system installed in the car is equipped with a security code, before disconnecting the battery, make sure that you have the correct combination to activate the audio system!
Front doors
1.Remove the door rear view mirror (see Section Removal and installation of external rear-view mirrors).
2. Remove the door trim panel and moisture barrier (see Section Removal and installation of panels of an internal upholstery of doors).
3. Remove the inner and outer sealing tapes (refer to illustration Front door and its components).
4. Turn away two bolts of fastening of the directing trench of glass and take out glass from a door outside and up. Pry up the chute and carefully remove it.
5. Installation is carried out in the reverse order. Track reliability of a snap-in and a tightening of fixture.
Rear doors
Rear door assembly design
1 - Models with a single lock; 2 - Door lock; 3 - Fixed rear window with facing sealing tape; 4 - Glass; 5 - External sealing tape; 6 - Guide tape facing the window opening; 7 - Dividing bar; 8 - Outer handle; 9 - Lock off button; 10 - Loop; 11 - Door lock; 12 - Internal sealing tape; 13 - Door opening limiter; 14 - Window regulator; 15 - Service hole cover; 16 - Internal handle; 17 - Armrest; 18 - Switch for controlling the operation of the power window; 19 - Interior upholstery panel; 20 - Models without power windows; 21 - Window regulator; 22 - Retaining ring; 23 - Bushing; 24 - Regulator knob
1. Remove the inner and outer sealing tapes (refer to illustration above).
2. Remove the dividing strip, the rear fixed window with a sealing facing tape and the guide tape for facing the window opening.
3. Remove door lock latch assembly with outside handle (see Section Removal and installation of latches, lock cylinders and door handles).
4. Remove the power window regulator (see Section Removal and installation of regulators of window regulators).
5. Remove door glass.
6. Installation is carried out in the reverse order.