Windshield wipers and washer: 1 - wiper arm, 2 - ventilation grille, 3 - seal, 4 - wiper drive assembly, 5 - wiper drive motor, 6 - washer nozzles
Removing the windshield wiper
1. Remove the following parts:
- A) Windshield wipers.
- b) Car hood ventilation grille.
2. Remove the wiper motor
- A) Disconnect the connector, then remove the three screws.
- b) Remove the cleaner motor with traction.
Windshield wiper installation
1. Install the following parts:
- A) Electric motor cleaner with traction.
- b) Hood ventilation grill.
2 Install the windshield wiper arms.
- A) Install the wiper arms. then turn the wiper on and off.
- b) Check Distances "A" And "IN", shown in the figure and, if necessary, adjust the position of the wiper arms.
- And about 30 mm
- H approx 29mm
- e) Tighten the nut. Tightening torque 22 Nm.
Removing the tailgate wiper
Note: when removing and installing, follow the assembly drawing "Tailgate".
1. Remove the wiper arm.
2. Remove an overlay of a door of a back.
3. Remove the wiper motor.
- A) Disconnect the connector, then unscrew the mounting bolts.
- b) Remove the electric motor.
Installing the tailgate wiper
1. Install the following parts-
- A) Wiper motor.
- b) Tailgate trim.
2. Install the wiper arm
- A) Install the wiper arm, then turn the wiper on and off.
- b) Check the distance shown in the figure and, if necessary, adjust the position of the wiper arm. CALDINA: approx. 30 mm.
- V) Tighten the nut. Tightening torque 5.4 Nm.