1 - internal return spring,
2 - external return spring,
3 - control lever No. 1,
4 - damper control lever,
5 - control lever No. 2,
6 - position sensor of the injection pump control lever,
7 - cover,
8 - damper (modifications),
9 - damper bracket,
10 - drive system for increasing the idle speed when the air conditioner is turned on,
11 - wire with connector,
12 - cap,
13 - control unit for the fuel cut-off solenoid valve,
14 - solenoid valve for cutting off the fuel supply,
15 - cover,
16 - annular sealing gasket,
17 - spring,
18 - valve,
19 - coarse filter,
20 - curly puck,
21 - heating control drive,
22 - key,
23 - speed sensor,
24 - speed sensor (modifications),
25 - gasket,
26 - lever axis,
27 - adjusting washer of the regulator,
28 - control lever,
29 - puck,
30 - spring,
31 - pin,
32 - regulator cover,
33 - adjusting screw for maximum speed,
34 - idle speed adjusting screw,
35 - fuel adjustment screw,
36 - fitting corrector for boost pressure,
37 - guide sleeve,
38 - spring,
39 - pusher rod,
40, 42 - saddle,
41 - aperture.
1 - annular sealing gasket,
2 - regulator shaft,
3 - adjusting washer of the regulator drive gear,
4 - washer No. 1,
5 - regulator weight holder,
6 - washer No. 2,
7 - regulator bushing,
8 - retaining ring,
9 - separator,
10 - bearing,
11 - thrust ring,
12 - load regulator,
13 - gasket,
14 - regulator lever system,
15 - ax supply fitting,
16 - roller holder,
17 - clutch spring,
18 - cam washer,
19 - clutch,
20 - roller and washer, clamp,
22 - locking pin,
23 - axis of the leash,
24 - key,
25 - damping elements,
26 - blade,
27 - drive shaft,
28 - regulator drive gear,
29 - drive shaft washer,
30 - booster pump cover,
31 - booster pump rotor,
32 - clip booster pump,
33 - plug of the distribution head,
34 - a bolt of a stopper of a distributive head,
35 - discharge valve fitting,
36 - spring,
37 - discharge valve,
38 - clamp,
39 - clamp,
40 - dosing sleeve,
41 - lower spring seat,
42 - lower thrust ring,
43 - adjusting washer of the geometric start of the feed, pump plunger,
45 - upper thrust ring,
46 - plunger spring,
47 - upper seat of the spring,
48 - plunger spring adjusting washer,
49- plunger guide spring,
50 - distribution head,
51 - lever support spring,
52 - left cover of the injection advance machine,
53 - adjusting screw of the automatic injection advance,
54 - spring washer,
55 - external spring of the automatic injection advance,
56 - internal spring of the automatic injection advance,
57 - insertion into the piston of the automatic injection advance,
58 - injection advance automatic piston,
59 - right cover of the injection advance machine,
60 - stuffing box,
61 - pump housing,
62 - pressure reducing valve.