Share information:
Diesel engine management system Toyota Carina 6 (T190)
Conclusions of the electronic control unit (2C)
Note: for more information on checking the elements of the diesel electronic control system, refer to the similar sections of the chapter "fuel injection system".
Note: for more information on checking the elements of the diesel electronic control system, refer to the similar sections of the chapter "fuel injection system".
Checking the coolant temperature sensor
Measure the resistance between valve terminals under specified conditions. Resistance: 20°C - 2-3 kOhm 80°С - 0.2-0.4 kOhm
Measure the resistance between valve terminals under specified conditions. Resistance: 20°C - 2-3 kOhm 80°С - 0.2-0.4 kOhm
Checking the pressure sensor
1. Voltage test. A) Turn on the ignition. b) Measure the voltage between terminals VC-E2 of the ECM. Voltage - 4.5-5.5 V Note: Testing is done with the connector on the wiring harness side connected. V) Measure the...
1. Voltage test. A) Turn on the ignition. b) Measure the voltage between terminals VC-E2 of the ECM. Voltage - 4.5-5.5 V Note: Testing is done with the connector on the wiring harness side connected. V) Measure the...
Lever Position Sensor
1. Resistance check. Measure the resistance between the VC-E2 terminals. Resistance - 2.8-5.2 kOhm 2. Check for a change in resistance between terminals VE-E2 when the accelerator pedal is fully depressed/released....
1. Resistance check. Measure the resistance between the VC-E2 terminals. Resistance - 2.8-5.2 kOhm 2. Check for a change in resistance between terminals VE-E2 when the accelerator pedal is fully depressed/released....
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar sections for other Toyota models
➥ User manual: Governing bodies Toyota Camry XV30 (2001-2006)
➥ General information: Controls and instruments Toyota Cruiser 100 (1998-2007)
Link in different formats to this article
TEXTHTMLBB Code
- General information
- User manual
- Maintenance
- Power unit
- Engines 4A-FE, 5A-FE, 7A-FE
- Engines 3S-FE, 4S-FE
- Diesel engines 2C
- Engine repair
- Cooling system
- Lubrication system
- Fuel system
- Control system (diesel)
- Fuel injection system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Air conditioning and heater
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Breakers and switches
- Electrical circuits
- General information
- Introduction to the manual
- Power unit
- Gasoline engines
- Diesel engines
- Lubrication system
- Cooling system
- Fuel system (carburetor)
- Fuel system (injector)
- Ignition system
- Transmission
- Clutch
- Car gearbox
- Drive shafts
- Chassis, running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Electrical equipment
- Power devices
- Electrical circuits