Car headlights and lighting Toyota Carina 6 (T190)

Lamp Replacement Precautions
1. Do not touch the glass part of the lamp as this will shorten its life. 2. New, the lamp must be the same power as the old one.

Headlight adjustment
1. Preliminary operations. A) Adjust tire pressure. b) Sit one person in the driver's seat. V) The battery must be charged during adjustment. 2. Adjust the position of the headlights using the adjusting screws. 1 -...

Headlight Bulb Replacement
1. Remove headlight assembly. 2. Remove the protective cover and casing. 1 - front turn signal and fog lamp (right), 2 - front right dimension, 3 - right headlight, 4 - lighting relay when turning, 5 - fog lamp relay, 6...

Replacing the front marker lamp and repeater
1. Remove the front marker assembly. 2. Disconnect the connector and remove the lamp. 3. Installation is made in the reverse order of removal. Front position/corner lamp 5/21 W Repeater - 5W

Removing the front marker and headlight
1. Removing the front clearance. A) Loosen the screw. b) Pull the front marker towards the front of the vehicle. V) Disconnect the connector and remove the front marker. 2. Removing the headlight. A) Remove the grille...

Installation of the front clearance and headlights
1. Installing the headlight. A) Connect the connector. b) Install the three bolts in the order shown in the figure. V) Install the grille. 2. Set the front gauge. 3. Check the operation of the headlights.

Replacement of fog lamps and direction indicators
Anti-fog headlight 1. Remove the fog lamp. 2. Remove, turning counterclockwise, a casing. 3. Remove the lamp by loosening the clamp. Fog lamp - 55 W Front turn signal 1. Remove the fog lamp. 2. Disconnect the connector...

Removal and installation of fog lights and direction indicators
1. Unscrew the screw, bend the clamps. 2. Remove a fog lamp and disconnect a socket. 3. Installation is made in the reverse order of removal.

Replacing taillight bulbs
1. Remove the rear combination lamp. 2. Remove the lamp together with the connector. 3. Remove the lamp. Rear clearance and brake light - 21/5 W Rear turn signal - 21W Reversing lamp - 21 W

Removal and installation of a back lantern
1. Remove the 4 clips and remove the rear trunk lining plate. 2. Remove the mat. 3. Remove 7 clips and remove the rear trunk lining. 4. Removing the rear light. A) Disconnect the connector. b) Remove three caps. V)...

Replacing license plate lamps
1. Loosen the two screws and remove the lamp cover. 2. Remove the lamp. License plate light - 5 W

Removing and installing license plate lights
1. Remove the 4 clips and remove the rear trunk lining plate. 2. Remove the mat. 3. Remove 7 clips and remove the rear trunk lining. 4. Removing the bracket assembly with lamps. A) Disconnect the clips and connector on...

Checking the upper brake light (on the spoiler)
let me down "+" battery to the output "2", and to the conclusion "1" and make sure the brake light comes on. Note: Observe the correct polarity of the battery connection.