A) Windshield wipers.
b) Hood seal and ventilation grille.
V) Sun visors.
G) Internal mirror.
d) (Sunroof Models). Sunroof control panel and front dome light assembly.
e) Upper finishes of the front pillars.
and) Handle.
2. Remove the windshield molding,
A) When removing the molding, be careful not to damage the clips. The mounting locations of the clamps are shown in the figure.
b) Remove the windshield molding as shown.
3. Remove the windshield.
A) Pull the string from the saloon and fasten the ends of the string to wooden blocks.
Using a string, cut off the adhesive layer as shown in the figure and remove the glass.
Attention: when cutting, leave as much glue as possible on the body.
Note: Apply adhesive tape to the outer surface of the windshield to avoid scratching the surface.
Attention: when removing the glass, take care not to damage the painted surfaces and finishes. To avoid damaging the panel when removing the windshield, place a plastic sheet between the string and the panel.
b) Using a special tool, cut off the adhesive layer as shown in the figure and remove the glass.
Attention: when cutting, leave as much glue as possible on the body.