Car steering Toyota Camry 1 (XV10)

Steering Specifications
Tightening torques Steering Bolts of fastening of the block of an air pillow of safety to a steering wheel 8 Nm steering wheel nut 35 Nm Steering gear mounting bolts 150 Nm Coupling bolt of the universal joint of a...

Steering wheel — removal and installation
Removing Attention! If your radio has an anti-theft code, check that you have the pairing codes before disconnecting the battery. Attention! On models since 1993, the airbag system is disabled if the battery is...

Tie rod ends — removal and installation
Removing 1. Raise the front of the car and secure it on stands. Remove the front wheel. 2. Lock the tie rod and loosen the tie rod locknut a quarter of a turn. Do not move the locknut from this position as it will serve...

Replacement of protective covers of steering gear
1. Raise the front of the car and secure it on stands. Remove the wheel. 2. Remove the appropriate tie rod end. 3. Loosen the clamps and slide the protective cover over the steering rod. 4. Clear steering draft and...

Steering gear — removal and installation
Removing Steering gear mounting elements 1 - cotter pin; 2 - protection of the right front wing; 3 - stabilizer bar; 4 - protection of the left front wing; 5 - cotter pin 1. Set the front wheels to drive straight ahead....

Power steering pump — removal and installation
Power steering pump on models since 1992 with four-cylinder engines 1 - drive belt; 2 - return hose; 3 - pressure hose; 4 – a bolt of fastening of a pressure hose; 5 - gasket; 6 - pump; 7 - vacuum hoses; 8 - protection...

Bleeding air from the power steering system
Air must be removed from the system after disconnecting the hydraulic elements of the system. 1. Remove the cap of the nutrient tank and check the fluid level. 2. With the engine off, turn the steering wheel slowly from...