Doors, locks and windows of the car Toyota Camry 1 (XV10)

Trunk Lid — Adjustment
Possible direction of travel for tailgate adjustment 1. Open the trunk lid. 2. Unscrew the plastic screws, remove the clips and remove the trunk trim. 3. Disconnect the electrical connectors from the trunk. 4. Using a...

Rear door — removal and installation
1. Open the tailgate and hold it in this position. 2. Disconnect from a back door electric sockets. Using a marker, mark the position of the rear door hinge bolts. 3. While supporting the rear door, remove the door...

Support leg replacement
Hood 1. Open the hood and hold it open. Use a strong, quick motion to remove the top of the support strut from the hood ball joint. 2. Unscrew the bolt securing the lower part of the support strut and remove the strut....

Door upholstery — removal and installation
1. Remove the ground wire from the battery. 2. Open the front door. Using a screwdriver blade as a lever, remove the decorative trim on the inside door opening handle. 3. On manual window models, fully close the window...

Doors — removal and installation
Removing 1. Remove the door trim. Disconnect the electrical connectors inside the door and remove them from the door so that they do not interfere with the removal of the door. 2. Support the door with stands or jacks,...

Lock, lock cylinder and door handles
1. Remove the door upholstery and protective film from the door. Door lock Elements of fastening of the lock of a door 1. Through the holes in the door, disconnect from the lock the rods of the external door opening...

Door glass — removal and installation
Front door 1 - backlight; 2 - armrest; 3 – decorative overlay of the internal handle; 4 – the internal handle of opening of a door; 5 – an internal arm of a door; 6 - front lower glass guide; 7 - power window; 8 - rear...

Window regulator — removal and installation
1. Remove the door upholstery and protective film. 2. Remove door glass. 3. Unscrew bolts and remove an internal arm of a door. 4. Unscrew the fastening nuts, disconnect the electrical connector and remove the power...