Car automatic transmission Toyota 4Runner 2 (N120)

Automatic transmission — design description
Automatic transmission (type A340) four-wheel drive vehicles 1. Transfer box lever handle; 2. Top panel of the front section; 3. Top panel of the rear section; 4. Front section box; 5. Transmission control mechanism...

Technical data of automatic transmission
Transmission blocking system Coil resistance of gear detent solenoid 21 - 27 Ohm Ignition key solenoid resistance 12.5 - 16.5 ohms Tightening torques (N·m) Bolts of fastening of the hydrotransformer to a leading disk 37...

Diagnostics of malfunctions of automatic transmission
Attention! The main reasons for the abnormal operation of the transmission can be a malfunction of the engine (power loss), incorrect adjustments, failures of the hydraulic transmission system, mechanical drive and...

Damper cable — check, adjust and replace
A43D transmission valve body bolts Transmission valve body bolts А34О Check and adjustment 1. Make sure the throttle is fully closed when the pedal is released. 2. Check cable tension. 3. Check the distance between the...

Transmission linkage — adjustment
1. Move the selector to all positions, and the lock should be felt. If operation is not felt, or the pointer does not match the designations, then the thrust must be adjusted. 2. Raise the vehicle. 3. Loosen the nut...

Interlock switch — check and adjustment
The switch blocks the engine from starting in all selector positions except P and N. Otherwise, the switch must be checked or replaced. Examination 1. Raise the vehicle. 2. Disconnect the connector from the switch. 3....

Gear locking system — check and replace
Details of the gear locking system 1. Key interlock solenoid; 2. Stop signal switch; 3, 8. Processor unit of the fixation system; 4, 6. Locking solenoid; 5, 7. Limit switch Checking and replacing parts 1. Remove lower...

Gear change lever — removal and installation
1. Remove the rear section top panel and rear heater control panel (see subsection 4.10 ). 2. On all-wheel drive vehicles without a front gear selector (2) Remove the transfer case lever handle. On vehicles with a front...

Removal and installation of automatic transmission
Removing 1. Disconnect the battery from the ground. 2. Remove the dipstick for the fluid level indicator. 3. Disconnect the throttle cable, for which loosen the adjusting nuts, remove the cable from the bracket and...